HH HILAND Bamcbase Womens Mountain Bike, 24 26 Inch 21 Speeds Hybrid Commuter Bicycle for Adults, Sport Hardtail Trail MTB

The back tire was bent and flat on frame

I did a lot of research before I bought. Not disappointed. Took me about an hour to assemble the bike. It was very straightforward and easy. Watch the video that’s on this page and you can also refer to the booklet.

Great value. I’m 5’4 and the 26 inch is fine for me. The bike is not too heavy but it is also solid and has weight to it. Some of the roads I ride on are quite bumpy and the suspension works well. Very comfortable. It’s a great bike for the money. Update: I had it a couple months. I ride every day about 9 to 10 miles. I ended up having to change the shifter to a clicker. The one that came with the bike is too stiff. I couldn’t get it into third gear comfortably. With a new shifter it works perfectly. The bike shop did a health check on it and said it’s a good bike. Brakes are good.. Just needed to add some air to the tires. Overall, very happy with this bike.

Hiland is a great company and there customer service is great ! I had a problem and they sent me a free Helmet for the bike free of charge

This is a bike. It’s got twenty one speeds and the tires are thin and a little knobby. You have to assemble part of it. The front is the wrong way so make sure you turn that around before you put the front tire on. The front brakes should be in front of the bike so the pedals have room. The tires are one way so make sure you put it going in the right direction. Also had to adjust the brake at the tire because they were rubbing and the tires weren’t moving. Make sure seat is tight so it doesn’t slide down or move. The pedals are marked which way they go and the left pedal is reverse thread. When putting handle bars on loosen top with allen wrench and slide it through then tighten allen bolt once all the way in. There is a bolt on front where front tire is supposed to go just remove it it is not an axle it’s just there for shipping purposes. You have to detach brakes at the center rubber part with the wire to put in front tire. Squeeze the sides holding the wire and little rubber piece and and pull out nub connected to wire. Then put on front tire and when tightening front tire there are these hook washers make sure they hook into a little hole before tightening. Then put wire and brakes back together and adjust them if they are stopping the tire from moving. Comes with directions and tools to put together but didn’t notice them till after put together. Some things are easier if you have a set of tools but most helpful is a 15mm wrench for the pedals and a 15mm deep socket wrench for the front tire. Anyways it seems to ride ok and the brakes seem to work so well see if it holds up. The front tire and rear tire say to put them at 40psi and as of now I put them at 35psi. Both tires were around 10psi before filling. Good find.

The assembly instructions don’t explain assembly well and give options for different bike types rather than for the one you bought. There’s no other help available. They leave you stranded to figure things out on your own.